Vintage medicine cabinet can be a real lifesaver when it comes to the bathroom mess. A medical cabinet allows you to neatly store toiletries and other items, which will reduce the mess in your bathroom. Unfortunately, some bathrooms are not equipped with medical cabinets, and crowded sink tops often result. The good news is that you can install a medical cupboard yourself, as long as you have access to some simple hand tools. As long as you can cut and measure, you can install your own medical closet in an afternoon. To install a recessed vintage medicine cabinet in a bathroom. Please follow the instructions below.
Draw a contour on the bathroom wall where you want to install the vintage medicine cabinet. Check the dimensions are the same as the cabinet you purchased. Scan the outlined area with a control detector to locate the rules inside the wall. You’re probably going to get around a stud, so be prepared. Select the location where the duplicate is located. Cut a 4 inch 4 inch square on each side of the tab, using a jigsaw. Remove the plaster square from the wall so you have two square holes. Shine a flashlight in the holes and check for any pipes or electrical wires that may be in your way.
Then for install a recessed vintage medicine cabinet in a bathroom, remove any insulation inside the wall that is in the area where you will place the cabinet. Use an arc sheet to cut through the nails holding the stud to the adjacent wall. Wrap the sheet in silver tape and use it as your handle; this allows you to get between the stud and the rear wall. Cut the stud out of the wall using your hand saw. Be sure to cut studs in parallel with both the top and bottom of the plaster. Place 2 of 4 aboard the wall horizontally to create a frame for the cabinet.