Bathroom Wall Cabinets – In terms of construction and remodeling, some projects tend to get more attention, as well as create the greatest impact on the budget. The kitchen and the bathroom are on this list. While the remodeling of a kitchen can be expensive and time-consuming, many bathroom projects are simple and very economical. Installing a bathroom mirror with cabinets, for example, can be done in a few hours with very basic tools. The simplest way to install a mirror Bathroom furniture is to use a surface mount configuration. Firstly, remove the mirrored doors for the bathroom furniture. Generally, this is achieved by loosening the hinges. Put aside the doors.
Determine the location of the bathroom wall cabinets with mirror. With the help of a friend, keep the bathroom cabinet against the wall. Center the cabinet over the sink about 40 inches from the floor. Place the level in the shelf cabinet to make sure it is sitting evenly. Locate the posts in the layout area using a stud locator; Mark with a pencil. If you cannot find suitable studs in the immediate area, you will need to use hollow wall anchors, installed according to the package instructions. Measure the location of the poles in relation to the layout of your cabinet. Transfers these marks to the bathroom mirror with cabinets, determine the best placement of your screws. The screws should penetrate the reinforcement strip on the back of the cabinet door.
Drill holes part in the wall. You have to clean the drywall and just begin to penetrate the bolt. Drill the holes completely through the back of the bathroom wall cabinets door. Hold the furniture against the bathroom wall firmly, enlisting the help of a friend. Verify that the cabinet is level, adjust its position as necessary. Match the holes in the wall with the holes in the cabinet. Use the screwdriver to fix the cabinet to the wall with the included screws, making sure that the screws sink deep into the stud. Ideally, you should have at least four screws: two on the top of the cabinet and two on the bottom. The top screws should catch the reinforcing strip on the back of the cabinet.